Limecrete floor

The ground floor – removing cement and replacing it with limecrete

The cement floor was the biggest single problem. It had to be removed to make the building habitable, because headroom on the ground floor was well under 6 feet. The plan was to drop the floor 8 inches. The architects advised, and indeed the conservation officer insisted, on a limecrete floor, using expanded glass balls from power station waste as a lightweight filler instead of gravel. Underneath was a thick layer of a similar expanded glass, for insulation, and also to allow water to drain away quickly from beneath the building. The winter water table, as measured by the well outside, is less than half a metre below the floor.

The cement floor, which was removed and replaced with limecrete
The cement floor, which was removed and replaced with limecrete

Limecrete, bought from Ty-Mawr, is a modern variant on the old materials, and its use has been a resounding success. Continue reading “Limecrete floor”

First stage repairs



We gained planning permission and listed building consent for structural repairs to the building, installation of services, a new vehicle entrance and construction of a cart-lodge style garage and also a small extension – essentially, a porch, though with a shower room squeezed in. We decided we would split this into several phases, leaving the porch extension, some of the repair work and the garage until later.

The repairs under Phase I were undertaken by Robert Norman Construction of Framlingham. The main items were: Continue reading “First stage repairs”